Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
FIRE, EXPLOSION, BURN INJURY, CARBON
MONOXIDE POISONING
● The cooking appliance must be completely
separated and/or sealed from other air moving
or air consuming devices such as, but not limited
to, furnaces, microwave ovens, clothes dryers,
cooling fans and doors or drawers in common
cabinets. Failure to do so will affect the appliance(s)
combustion air supply by creating either a negative
or positive draft.
● NEGATIVE DRAFT caused by air moving appliances
may draw the top burner flame down into or
toward the cooktop resulting in cooktop damage,
burn hazard, explosion possibility and/or carbon
monoxide buildup.
● POSITIVE DRAFT may blow out the top burner flame
during use resulting in an explosion and/or fire
hazard and/or injury to the occupants of the vehicle.
● DO NOT operate the appliance in excessive windy
conditions as this may cause a negative or positive
draft.
Trim Kit Installation (Sold Separately)
Trim kit types are available:
● One-Piece Trim Kit:
- FMAML09-SS-TK (2023050377)
- FMAML09-BL-TK (2023050378)
One-Piece Trim Kit Installation
Trim Kit x 1
1. Take out the microwave oven and the component(s) from
box and put on a flat surface.
2. Attach the trim kit onto the oven. (Fig. 1)
Fig. 1
PMA Screws 5/16" x 4
Fig. 2
3. Attach the trim kit onto the microwave oven with 4pcs
M4 x 5/16" (8mm) screws. (Fig. 2)
Fig. 3
4. Slide the microwave oven into the cabinet opening. (Fig.
3)
PMA Screws 5/8" x 4
5.
Fig. 4
6. Attach the microwave oven to the cabinet with 4pcs
M4 x ⁄ "
M4 x 5/8" (16mm) screws. (Fig. 4)
screw x 4
Electrical Connection
M4 x 5/8"
Connect the microwave oven to a 120 volt, 60 Hz, AC only,
screw x 4
15 amp or 20 amp dedicated circuit. It is recommended
that an individual circuit serving only the microwave oven
be provided.
- 6 -
CCD-0008388 Rev: 01.09.24
Publicidad
