Publicidad
Idiomas disponibles
Idiomas disponibles
EN
18
Attention
Please ensure to use the accessories provided along with the product to install this
electric water heater. This electric water heater can not be hung on the support
until it has been confirmed to be firm and reliable. Otherwise, the electric water
heater may drop off from the wall, resulting in damage of the heater, even serious
accidents. When determining the locations of the bolt holes, it shall be ensured
that there is a clearance not less than 0.2m on the right side of the electric heater .
This may be required during maintenance of heater.
How to install
•
This electric water heater shall be installed on a solid wall. If the strength
ofthe wall cannot bear the load equal to two times of the total weight of the
heater filled fully with water, it is then necessary to install a special support.
•
After selecting a proper location, determine the positions of the two holes
used for expansion bolts with hook Make two holes in the wall with the
corresponding depth and size matching the expansion bolts attached with the
heater insert the screws, turn the hook upwards, tighten the nuts to fix firmly,
and then hang the electric water heater on it (see Fig. 2).
Fig. 2
•
Install the supply socket in the wall. The supply socket should be 3 pin, single
phase, 230V/8.7 A. It is recommended to place the socket on the right above
the heater. The height of the socket to the ground shall not be less than 1.8m
•
If the bathroom is too small, the heater can be installed at another place.
However, in order to reduce the pipeline heat losses, the installation position
of the heater shall be as near as possible to the heater.
expansion bolt
(with hook)
Publicidad
