Publicidad
Idiomas disponibles
Idiomas disponibles
EN
20
SAFETY INSTRUCTIONS
•
The device is equipped with a water change indicator that cannot be
deactivated. When the water change indicator is on, the concentrated water
needs to be poured out and fresh tap water must be added (it is strictly
forbidden to keep adding water to the water tank).
•
It is strictly forbidden to move the device in any way. Before moving the
device, the water tank must be emptied.
•
Do not wash the housing with water.
•
Do not use multiple sockets and other electrical devices at the same time. Use
an outlet with at least 10 A.
•
Do not hang the water tank. Place it on a table board.
•
Do not fill cloudy tap water, ice cubes or other mixed liquids such as milk and
fruit juice into the water tank.
To avoid the risk of the spout becoming clogged with boiling water, do not
insert the water spout into the edge of the cup when removing water.
•
The drinking machine may only be used by children from the age of 8 and
people with physical, sensory or mental disabilities or a lack of experience and
knowledge, provided that they are supervised or instructed in the safe use of
the drinking machine and understand the risks involved. No child should clean
or maintain the machine without supervision.
•
If the power cord is damaged, it must be replaced by the manufacturer,
customer service or appropriate professionals to avoid a hazard.
•
'Stop using the device when the water temperature or ambient temperature is
below 5° C or above 38 °C.
•
If you take out low-temperature water immediately after taking out high-
temperature water, the fresh water temperature may be high; please be
careful to avoid scalding.
If the raw water does not meet the municipal tap water standard (including
high sludge levels and excessive TDS), filter element life may be reduced.
•
To avoid danger, please place the water purification and drinking machine
on a flat table top. (The inclination of the tabletop should not be greater than
10°).
•
Operating voltage range: 220-240 V~.
•
Before delivery from the factory, the whole machine will be filled with water
for a complete check, so it is normal that there is some residual water inside
the machine.
Publicidad
