Publicidad
Idiomas disponibles
Idiomas disponibles
EN
26
Please note:
•
The dispenser is equipped with quantity-based water output protection, and
the water output will be automatically stopped when 1000 ml of water has
been dispensed.
•
To avoid scalding, do not put your hand under the water spout when
dispensing hot water.
•
To avoid burns, please let some normal temperature water run out before you
turn on the dispenser for the first time and draw out hot water.
•
When the water tank with the transparent window is used for the first time,
the pipe will be blocked due to the air inside, which cannot fill the transparent
water level gauge. Drain this at a normal temperature to remove the air
inside.
•
When the water comes out, you can press any temperature button to stop the
water.
Manual temperature setting
Press „hot" for 3 seconds, the water dispenser enters temperature regulation
mode and the digital display shows „95". Press
degree and press
to increase the temperature by 1 degree. The adjustable tem-
perature range is between 85 °C - 95 °C. When the desired temperature is reached
and there is no operation for 5 seconds, the "hot" indicator will stop flashing.
Dispenser with cooling function
When you use the chilled water function for the first time, press the
and then press the water dispensing button to deflate the pipe until the water
comes out, then stop dispensing water.
When first used, the small water tank in the transparent window is only half full.
Click the button for normal temperature water and drain the water for 10 seconds.
When the water level rises in the transparent window, the water can be stopped.
You can press the cold water button ("COOL") for 5 seconds to turn off the cooling
function. If you press and hold the cooling function again for 5 seconds, you can
turn on the cooling function. (Applies to dispensers with cooling function).
to decrease the temperature by 1
button,
Publicidad
