ulsonix LCLEAN MINI M Manual De Instrucciones página 14

The washing machine should be installed in a firm and flat place with a maximum allowable inclination
angle of 2°. The washing machine should be placed at least 5cm away from the wall to prevent noise
during operation.
Preparation
•
1. The washing machine must be placed on a flat surface. The lower window of the washing machine
must not be blocked during use.
2. To ensure the safety of the appliance during operation, the washing machine must be fitted with
an ambidextrous plug. Do not connect the earth wire to a water pipe, gas pipe, heating pipe, etc.
3. Lay down the overflow hose. (Do not lay the hose when the appliance is on the drain function).
4. Use the water hose to connect the tap to the water inlet.
5. Adjust the water level to suit the fabric and weight of the fabric.
6. Turn the power on.
7. Separate light-coloured and faded clothes before washing.
8. Clean up pockets, take out coins, sand, hairpins, etc.
9. Knot the long strap, fasten the buttons.
10. Do not wash too much, shake the clothes loose before washing.
11. Put thin clothes, woollen clothes that are easy to wear into the mesh bag.
3.3. Device use
• Washing
1. Put the clothes and an appropriate amount of detergent in the drum. (Excessive detergent will
make it difficult to get rid of suds and may result in insufficient rinsing).
2. Turn on the tap valve, water supply and adjust the water level as required.
3. Set the water drain switch to standard.
4. Set the wash timer knob to the correct position and start the wash.
5. When you have finished washing, set the water drain switch to the drain position to drain the
water.
6. It is strictly forbidden to put feathered clothes into the centrifuge for dehydration.
Centrifugal drying
•
1. After draining the water, place the clothes in the right centrifuge and hold them in place.
2. Lower the safety cover and the spinning cover in turn.
3. Set the spin time to the appropriate time for the garment.
• Draining
1. When drying is complete, pour water into the spin drum for 20-30 seconds.
2. According to the spinning process, dry the clothes for 1 minute and then spin again for 1-2
minutes.
• Rinsing
1. After drying, when the spin-dry drum finally stops, open the spin basket, safety cover and spin-
dry cover in sequence, remove the clothes to the wash tub and prepare for rinsing.
2. Apart from not having to add detergent, the rinsing process is no different from the washing
process.
CAUTIONS
Unplug the power cord and turn off the tap when machine is moved, not used, or cleaned. Don't pull the
plug with wet hand. Cut off the power when the machine is not being used.
Do not excessively bend, stretch, twist, tie, or modify the power cord. If the power wire is damaged, please
replace it by the special one supplied by manufacturer or service office. Clean the dirty on the plug.
Do not install in a humid place. Do not place the wet clothes on the top of the washing machine.
The water temperature shall not exceed 50°C when washing with warm water.
EN