EHEIM incpiria 230 Manual De Instrucciones página 17

English
‧ A stand can be used underneath for horizontal alignment.
‧ The central stand can be adjusted with a screwdriver from the inside of the cabinet.
‧ Ensure that all stands are in full surface contact.
Setting the aquarium (⌦C1/C2)
WARNING! Personal injury or material damage.
The aquarium must not be transported or carried when it is filled.
CAUTION! Material damage.
No foreign bodies, mats or bases must be placed between the aquarium and base cabinet.
▶ Thoroughly clean the top side of the base cabinet and the lower side of the aquarium base.
▶ Remove any foreign bodies, mats or bases.
1. Place the empty aquarium on the base cabinet. Ensure that the connections lie in the section of the
base cabinet's top side.
The aquarium of the incpiria duo aquarium combination can, depending on where it is set up, be
rotated 180 degrees and placed onto the base cabinet!
Adjusting/removing the doors
‧ You can readjust the doors (⌦D).
‧ The doors can be quickly removed/attached via the quick-release function (⌦E).
Installing the drains (⌦F1/F2)
‧ incpiria 230, 330 and 430 as well as incpiria 430 duo have one drain.
incpiria 530 has two drains.
incpiria 630 has four drains.
‧ The drain/drains are factory-installed.
‧ Hint: Install an EHEIM double tap between the drainpipe and the filter to simplify maintenance.
1. Check whether the drain(s) ① are secure.
2. Place the filter (optional) in the base cabinet.
3. Mount the hose ② of your filter onto the drain neck. Please observe the operating manual of your
filter.
Installing the inflow (⌦G1/G2)
1. Feed the inlet hose ③ through the hole in the aquarium bottom and through the supply shaft.
2. Install the inlet ④. Please observe the operating manual, installation set.
Installing the aquarium lighting (⌦H1/H2)
DANGER! Personal injury or material damage.
▶ Heed the operating manuals for the accessories, especially the chapters on safety, commissioning
and operation!
1. Install the EHEIM powerLED+ lighting ⑤ in accordance with the corresponding operating manual.
2. Feed the mains cable through the supply shaft into the base cabinet.
17