Descargar Imprimir esta página

YATO YT-55801 Manual Original página 12

Máquina de limpieza ultrasonidos para taller

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
EN
Recommendations for connecting the product to the power supply
Before connecting the product to the power supply, make sure that the voltage, frequency
and performance of the power supply correspond to the values shown on the product's rat-
ing plate. The plug must fi t into the socket. It is forbidden to modify the plug or socket in any
manner to make them fi t. The product must be connected directly to a single outlet of the
mains. It is forbidden to use extension cords, adapters or double outlets. The mains circuit
must be equipped with a protective cable and 16 A protection. Avoid contact between the
power cord and sharp edges and hot objects and surfaces. During operation, the power cord
must always be fully extended and the position of the power cord must be set so that it does
not become an obstacle during product operation. The power cord should not be placed in a
manner which would pose a risk of tripping. The power supply socket should be located in a
place where it is always possible to quickly remove the product power cord plug. Always pull
the power cord by the plug housing when unplugging it, never by the cord. If the power cord
or the plug is damaged, immediately disconnect it from the mains and contact an authorised
service centre of the manufacturer for replacement. Do not use the product with a damaged
power cord or plug. Use only the power cable supplied. The power cord or plug cannot be
repaired and must be replaced with a new one that is free of defects if these components are
damaged. Do not touch the power cord plug with wet or damp hands.
Instructions for use
WARNING! The product heats up to a high temperature during operation, do not touch the
walls of the product while it is in operation, there is a risk of serious burns. The product is
not intended for use by children and people with impaired physical or mental abilities, or by
people without experience in or understanding of the operation of the product. Unless they
will be supervised or instructed to use the product safely, in a manner ensuring that the risks
involved are understood. Children should not play with the product.
Wear gloves and safety goggles before starting work. The cleaner should only be used in-
doors, in dry and well ventilated area. Do not use the cleaner unsupervised. When fi lling the
tank, make sure the unit is disconnected from the power supply and the drain valve is closed.
It is forbidden to start the device with an empty tank and to use the cleaner with a low level
of fl uid in the tank to avoid damaging the transducers and the heater. Fill the tank with the
correct amount of fl uid before starting the unit. If the fl uid level has decreased, e.g. due to
evaporation, switch off the unit and, taking precautions, top it up. Use only cleaning agents
designed for ultrasonic cleaning. The use of fl ammable fl uids e.g. petroleum, alcohol,
petrol, solvents is prohibited. This could cause an explosion or fi re. The use of solu-
tions containing abrasive materials and acid-based or alkaline fl uids is prohibited.
Such agents can cause corrosion or damage to the product tank. Only water-based
solutions should be used. The right choice of cleaning agent for the material being cleaned
will result in better cleaning performance and also prevent damage to items such as soft
metal. The fl uid should cover the object, but it should not exceed the level of the upper edge
of the basket. Basket handles must not be covered by fl uid. Consider that items placed in the
basket will raise the fl uid level. It is forbidden to throw objects into the tank, as this can dam-
age the tank and the transducers. Items to be cleaned should be cleaned using a basket. It is
O R I G I N A L
I N S T R U C T I O N S
12

Publicidad

loading

Este manual también es adecuado para:

Yt-55803