Publicidad
Idiomas disponibles
Idiomas disponibles
Humidifier
Operation
Your new Sears humidifier is designed to
satisfy home humidity requirements
through the principle of evaporation of
water in the air.
After water is added to the humidifier, the
filter begins to soak up the water and wilI
become saturated in approximately 30
minutes. Air drawn in through the open-
ings in the lower housing passes through
the filter by means of a circulation fan.
As air passes through the filter, moisture is
absorbed into the air and then released in
the form of vapor. No water droplets will
enter the home. All evaporation into the air
takes place in the humidifier, which means
that the residue left by evaporating water
is not passed into the home, but remains
in the filter.
This natural process of evaporation helps
eliminate the chance of white dust in the
humidified output air.
CAUTION:
Use onmy 42-14900 EPA
Registered
Bacteriestat
avaimabme
from SEARS Retail store. Under no
circumstances
should
you use water
treatment
products
designed
for
Roto beretor Umtrasenic humidifiers.
Humidified
air is
then reReased
through
the top
Dry'air
enters
through
the louvers
in the
housing
CAUTION: To reduce the risk of
injury, fire or damage to humidifier,
use onmy cmeaners specifically
recom_
mended for humidifiers.
Never use
flammabJe,
combustibme
or poisonous
materials
to clean your humidifier.
To
reduce the risk of scamds and dam-
age to humidifier,
never put hot water
in humidifier.
Unpacking
and Assemb/y
Your new Sears Kenmore humid[tier is
supplied with four swivel casters for ease
of maneuverability.
Remove the casters
from the top of the packing material
inside the carton. The casters press into
the bottom of the base at the locations
shown. To make assembly easier remove
the water bottle, housing assembty and
filter and flip the base upside to install
See steps 2-4 of "Replacement
and Care
of Filters" section on page 12 for proce-
dure. Take care not to damage the floats
or base assembly if choosing this
method of assembly. Press casters into
location beside X.
Note: Casters should be installed manu-
ally. Do not use any tools to install them.
Once installed return the unit to its origi-
nal state and proceed to "Location
Instructions.
Publicidad
