Publicidad
Idiomas disponibles
Idiomas disponibles
4. Listen for air bubbles. Look for leaks
around the "E-Z-Fill Side-Cap" and
valve plunger.
5. If you hear air bubbles or see leaks,
retighten the "E-Z-Fill Side-Cap" and
repeat steps 1-4.
Wipe off excess water from the bottle.
Position the water bottle back into the
humidifier base to the right of the grille.
The "E-Z-FilI Side-Cap"
must be facing
outward. When positioned
properly, the
plunger will open and water will flow into
the base. The base will hold the entire
contents of the water bottle. Allow up to
one minute for the water to flow into the
base. Once the bottle is empty, remove it
and refill it as mentioned earlier. Return it
to the right side of the grille. The humidi-
fier is now filled to capacity.
The water bottle may be filled at anytime
as necessary during operation. To benefit
from Iess frequent filling let the humidifier
exhaust both the water from the bottle
and base before filling.
The unit is now ready for operation.
Operating
Humidifier
Controls
The operating controls of your Kenmore
Quiet Comfort whole house humidifier
are !ocated towards the front of the
humidifier.
Familiarize yourself with the controls.
Refer to the diagram of the control
area for the correct nomenclature
used in
this manual.
play indicates that the room humidity is
less than 25 %.
Digital
Display
To Operate
the Controls
Power Button
/ Light
When the unit is plugged in and the
power button is pressed once the red
power light wilI come on. The power light
will stay on until the power button is
pressed again turning the unit off or until
the unit is unplugged.
Digital Display
The digital display wilI also show read-
outs when the unit is turned on. Initially
there is a slight delay while the electron-
ics calibrate.
Two bars (- -) flash during
this time.
Once calibration is complete a
ROOM humidity reading between 25% -
95% will be displayed. A flashing 25 dis-
Refill
On
Light
Light
Note:
The default settings at initia! start-
up are WHISPER fan speed and 65%
SET humidity.
After desired settings are
selected by the user, they remain as
defaults as Iong as the unit remains
plugged in and there is no power inter-
ruption.
If the unit is unplugged the
originam default settings are employed.
IMPORTANT: Water damage
may
resuBt if condensation
starts to form
on windows
or walls, Humidity
SET
point shoumd be lowered
until
condensation
no monger forms,
Publicidad
