Publicidad
Idiomas disponibles
Idiomas disponibles
G
G
Please read this manual thoroughly and adhere to the instructions in order to avoid any danger or
damage due to misuse.
Thank you for purchasing this high quality, well-performing light effect IBIZA Light that will give you
entire satisfaction.
Remove package and check:
1. Open carton to check whether all necessary spare parts include accord the specification list. Please
contact distributor if there is something missing.
2. Check the appearance of machine and power line to see whether they have some obvious damage.
Please contact distributor once you find something and stop to use fog machine.
Installation:
1. Take away all packing material, specially the spray mouth.
2. Put the machine on a level surface and open the cover of liquid can.
3. Add high quality fog liquid in the machine and screw the cover of liquid can. Bad quality fog liquid will
damage fog machine.
4. Plug the remote control receiver into the remote control socket on the rear panel of the unit.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
MOUNTING
Orientation
This fixture may be mounted horizontally only, provided there is adequate room for ventilation
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the fixture in a level position using, a suitable
"C" or "O" type clamp.
When selecting installation location, take into consideration the ease of access to fill the tank and for routine
maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes
or restricted ventilation.
If the external flexible cable or cord of this unit is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
Fuse replacement:
Warnings: Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With your hands, unscrew the fuse holder from its housing, remove the damaged fuse from its holder and
replace with exactly the same type of fuse. Screw the fuse holder back in its place and reconnect power.
Exterior surface temperature under steady state conditions is 60°C.
B
-
9
0
0
W
F
B
-
9
0
0
W
F
Ref.: LSM900W
o
g
M
a
c
h
i
n
o
g
M
a
c
h
i
n
© C o p y r i g h t L o t r o n i c 2 0 1 4
e
e
2
Page
Publicidad
