Publicidad
Idiomas disponibles
Idiomas disponibles
5. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 5 in of cutting
line above out of each side of the trimmer head.
5.1"
(130
)
mm
=
10.4
REPLACE THE SPOOL
1. Push the tabs (19) on the sides of the trimmer head at the
same time.
2. Pull and remove the spool cover (20).
20
21
3. Remove the remaining spool (21).
4. Put the spool in the spool housing.
English
Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
5. Put the ends of the cutting lines through the holes.
6. Extend the cutting line to release it from the guide slot in
7. Push the tabs and install the spool cover onto the spool
8. Push the spool cover until it clicks into position.
5.1"
(130
)
mm
10.5
=
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.094" (2.4 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into the
3. With your finger between the lines, wind the lines equally
19
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.
11
NOTE
the spool.
housing.
REPLACE THE CUTTING LINE
NOTE
NOTE
slot in the center rim of the spool. Make sure that the line
snaps into position in the slot.
and tightly around the spool in the indicated direction.
EN
20
21
Publicidad
