Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Product Information: Cordless Reciprocating Saw
Product Safety Information
Intended Use:
This Cordless Reciprocating Saw is designed for cutting plastics, berglass, composites, aluminum and sheet metal.
⚠
WARNING: Read all safety warnings, instructions, illustrations, and speci cations provided with this power tool. Failure to follow the
warnings and instructions may result in electric shock, re and/or serious injury. Save all warnings and instructions for future reference.
• Responsibly recycle or dispose of batteries. Do not puncture or burn batteries. Improper disposal may endanger the environment or cause
personal injury.
• Only use tools with appropriate voltage Ingersoll Rand batteries and charger. Use of any other batteries may create a risk of re, personal
injury or property damage.
For additional information, refer to Cordless Reciprocating Saw Product Safety Manual Form 47559326001, Battery Charger Safety
Information Manual Form 10567832 and Battery Safety Information Manual Form 10567840.
Manuals can be downloaded from ingersollrand.com
Product Speci cations
Voltage
Model
V, DC
C5101
20
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized test standards. The exposure to the user in a
speci c tool application may vary from these results. Therefore, on site measurements should be used to determine the hazard level in that
speci c application.
Blade Installation
Refer to Figure A on Page 33.
Always remove the battery pack, before installing, removing or adjusting any accessory on this tool, or before performing any maintenance
on this tool or any accessory.
1. Rotate the Chuck Sleeve (B) and hold it.
2. Position the Saw Blade (A) into the Blade Holder (C).
3. Release the Chuck Sleeve (B).
Blade Guide Adjustment
Refer to Figure B on Page 33.
Always remove the battery pack, before installing, removing or adjusting any accessory on this tool, or before performing any
maintenance on this tool or any accessory.
1. Open the Lock Lever (E).
2. Move Blade Guide (D) to desired position.
3. Close the Lock Lever (E).
Parts and Maintenance
Tool repair and maintenance should only be carried out by an Authorized Service Center.
Refer all communications to the nearest Ingersoll Rand O ce or Distributor.
Product Information: Battery
Product Safety Information
Intended Use:
These batteries are used as the power source for Ingersoll Rand Cordless Products.
⚠
WARNING: Read all safety warnings, instructions, illustrations, and speci cations provided with this power tool. Failure to follow the
warnings and instructions may result in electric shock, re and/or serious injury.
• Save all warnings and instructions for future reference.
EN-1
Strokes per
Battery Model
Minute
BL2022
3,000
WARNING
WARNING
Sound level dB(A)
Stroke Length
in. (mm)
† Pressure (L
1.25 (32)
85.2
Conforms to UL STD. 62841-1 and 62841-2-11.
Certi ed to CSA STD. C22.2 No. 62841-1 and 62841-2-11.
WARNING
WARNING
WARNING
Vibration (m/s
(EN 62841)
(EN 62841)
) ‡ Power (L
)
Level
p
w
93.2
12.1
TL-C5101-LIK_ed3
)
2
*K
1.5
4000415
Publicidad
