Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATi
The operation of any lawn mower can result in foreign objects thrown into the eyes, which can
result in severe eye damage, Always wear safety glasses or eye shields while operating your
lawn mower or performing any adjustments or repairs, We recommend a wide vision safety
mask over the spectacles or standard safety glasses,,
HOW TO USE YOUR LAWN MOWER
CAUTION: Do not run your lawn mower
without mulcher plate in place and door
closed or without an approved clipping
deflector or grasscatcher
in place.
Never attempt to operate the lawn
mower with the rear door removed or
propped open.
ENGINE SPEED (See Fig. 5)
The engine speed is controlled by a tever located on the
side of the engine. Fast ('_) position is for starting engine,
normal cutting and better grass bagging.
Slow (,_ll.)
position is for light cutting, trimming and fuel economy.,
ENGINE
ZONE
CONTROL
CAUTION: Federairegulations require
an engine control to be installed on this
lawn mower in order to minimize the
risk of blade contact injury. Do not
under any circumstances attempt to
defeat the function of the operator con-
trol, The blade turns when the engine is
running,
•
Your lawn mower is equipped with an operator pres-
ence control bar which requires the operator to be
positionedbehind the lawn mower handle to start and
operate the lawn mower,,
TO ADJUST
CUTTING
HEIGHT
(See Fig. 6)
°
Raise wheels for low cut and lower wheels for high cuL
°
Wheels are set in low cut for shipping, Adjust cutting
height to suit your requirements.
Medium position is
best for most lawns.
°
To change cutting height, squeeze adjuster lever to-
ward wheel.
Move wheel up or down to suit your
requirements,,
Be sure all wheels are in the same
setting.
TO EMPTY
GRASS
CATCHER
(See Fig. 7)
°
To remove grass catcher, release operator presence
control bar to stop engine.,
•
Lift up rear door and remove the grass catcher by the
handle°
°
Do not drag the bag when emptying;
it will cause
unnecessary wear,
ENGINE SPEED CONTROL LEVER
PRIMER
FIG. 5
LOWER WHEELS
RAISE WHEELS
FOR HIGH CUT
FOR LOW CUT
FIG. 6
9
Publicidad
