Hayward TracVac W3HSCTRACEU Manual Del Usuario página 13

EN
Skimmer Only Connection:
If your pool does not have a dedicat-
ed suction port, install one section of
hose into the skimmer together with
the Flow Regulator Valve, as shown.
If necessary, use the Hose Cone
Adapter to provide a proper seal.
NOTE: the Regulator Cap is not used
in this installation.
Connecting the Hoses
1. Attach the Float to the Leader Hose (the single section of hose that will connect to the
cleaner). The Float should be placed 50-60cm (20-24") from the cuff. Do not connect
cleaner at this time.
LEADER HOSE
Suction End Float
2. From the first section of hose at the suction source, connect together as many hose
sections as needed to reach the farthest point of the pool and then add the Leader Hose.
Refer to the diagram below and the top of page 6.
24 Use only hayward
1st Section
of Connector
Hose Skimmer
50-60cm (20 - 24")
20 - 24"
Do not connect
cleaner at this time
Hose Connection
genuine replacement parts
®
EN
Flow
Regulator
Knob
Flow
Regulator
Valve
Hose Cone
Adapter
Suction Source in Center of Pool
Use Flow Gauge to Check Water Flow
1. Submerge the entire length of hose to expunge all air.
2. Insert the Flow Gauge into the end of the Leader Hose.
3. Attach one end of the Double Hose Clip to the Leader Hose and the other end to the first
section of hose at the vacuum source. This will form a loop in the pool as shown below.
Double
Hose
Clip
4. With the air out of the entire hose, verify that the Leader Hose and Flow Gauge are
underwater and turn the pump ON. Adjust Flow Regulator Valve knob "faster" or "slower"
until the disc indicator in the Flow Gauge settles between "Maximum" and "Minimum"
flow. NOTE: If you have an extraordinarily strong pump, you may need to open the main
drain slightly.
5. Turn off the pump. Remove the Double Hose Clip and Flow Gauge from the Leader Hose.
Submerge the TracVac™ cleaner to remove all air and then connect the cleaner to the
Leader Hose. Cleaner installation is now complete.
Leader Hose
Leader Hose
Suction Source in Corner of Pool
Waterline
Hose "Loop" in Pool
Leader Hose
Use only hayward genuine replacement parts
®
1st Connector
Hose
(To Suction)
Flow Gauge
(Shown between
"Min" and "Max"
markings)
25