Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Checkpoints
If you encounter
a problem with the washer, first check the table below and try the
suggestions.
Does not turn on.
Does not start.
Water is not supplied.
After a cycle,
detergent
remains
in the automat c
dispenser.
•
Make sure you use rated power for the product.
•
Make sure the power cord is completely
plugged in.
•
Check the fuse or reset the circuit breaker.
o
o
o
Make sure
Make sure
Make sure
machine.
Make sure
o
o
the door is closed.
the water taps are open.
to press or tap Start/Pause to start the washing
Child Lock is not activated.
Before the washing machine starts to fill, it will make a series
of clicking noises to check the door lock and does a quick
drain.
•
Was the door opened during the spinning
cycle? Close the
door, and press or tap Start/Pause to resume.
•
The machine enters Standby or is in a soaking cycle. Please
wait.
•
Check the fuse or reset the circuit breaker.
sure you press or tap Start/Pause after selecting the
supply.
sure the water taps are open.
filter net at the water supply hose connector
clogged?
the filter net by brushing
with a toothbrush.
•
Make
water
•
Make
•
Is the
Clean
•
Is the water supply cut off? If the water supply is cut off, close
the tap and power off.
•
Straighten
the water supply hoses.
•
Open and close the door, then press or tap Start/Pause.
•
If the water pressure is low, it takes longer to start washing.
•
If the water level is not as high as necessary or lower than
expected, use the level selector to adjust the water level.
•
Make sure the washing machine is running with sufficient
water pressure.
•
Make sure the detergent drawer
is properly
inserted.
•
Remove and clean the detergent
drawer, and then try again.
50
English
\\TA771)0]
\\TA481771)0A_S'
03520D
01 ENindd
50
2015/4/16
9:38:41
Publicidad
