neno Tocco Manual Del Usuario página 11

a. Quick heat: use this mode for water or in exceptional situations milk, the
target temperature of the programme is 37°C. Insert the basket into the
steriliser, pour distilled water into the MAX line, then insert the water
bottle and replace the lid. Press the "FAST" button. In this mode, set the
volume of liquid to be heated, the temperature and the type of material
as allowed by the corresponding buttons. Press the button select tem-
perature/volume/material and then adjust the parameters by pressing
the buttons again. The unit will beep and start heating. During heating,
the screen will show the remaining heating time. When the rapid heating
is complete, the unit will beep and enter the 37°C maintenance mode
for 2 hours. Remove the bottle immediately when finished. Check the
temperature before serving to your baby. This mode is not recommended
for heating breast milk due to the large temperature spike.
NOTE: The actual heating time of the rapid warmer may vary due to
bottle material, bottle wall thickness, ambient temperature, initial food
temperature, bottle temperature, water temperature, amount of food.
Make sure the food is at a safe temperature to give to your baby before
serving. If the food is not warm enough, place the bottle back in the
warmer for 0.5-1 minutes.
b. Warming milk: use this mode to warm the milk. Insert the basket into
the steriliser, pour distilled water to the MAX line, then insert the milk
bottle and replace the lid. Press the DIY button and select the tempera-
ture with "+" and "-" , in this mode set the temperature to 37°C. The ap-
pliance will beep and start heating. During heating, the set temperature
will flash on the display. After 50 minutes, you will hear the unit beep
and it will enter the mode to maintain the displayed temperature for 23
hours and 10 minutes. If you are no longer using the appliance press the
"Power" button to switch off the heating.
c. Heating food: use this mode to heat semi-liquid products. Insert the
basket into the steriliser, pour distilled water into the MAX line, then
insert the food bottle and replace the lid. Press the DIY button and select
the temperature with "+" and "-" , in this mode set the temperature
between 35°C and 80°C. The appliance will beep and start heating. After
50 minutes, you will hear the unit beep and it will enter the mode to
maintain the displayed temperature for 23 hours and 10 minutes. If you
are no longer using the appliance press the "Power" button to switch
off heating.
d. Sterilisation: Place the basket in the steriliser, pour in 40 ml of distilled
water, then insert the bottle and/or accessories and replace the lid. Press
the DIY button and select a temperature of 100°C. While heating, the
display shows 100°C. Once heated to the set temperature, the device
will sterilise for 8 minutes. The appliance will beep to indicate that it
11