Cooper Hand Tools Wire-Wrap 14YB3 Manual De Uso página 8

English
Thank you for placing your trust in our company by purcha-
sing the "14YB3 Wire-Wrap". Production was based on strin-
gent quality requirements which guarantee the perfect ope-
ration of the device.
1. Caution!
Please read these Operating Instructions and the attached
Safety Information carefully prior to initial operation. Failure
to observe the safety regulations results in a risk to life and
limb.
The manufacturer shall not be liable for damage resulting
from misuse of the machine or unauthorised alterations.
The "14YB3 Wire-Wrap" corresponds to the EC Declaration of
Conformity in accordance with the basic safety requirements
of Directives 89/336/EEC and 73/23EEC.
2. Description
The Wire-Wrap Tool 14YB3 is equipped with a security insu-
lation and is powered by 230 V mains power. The universal
motor has a ball bearing on both sides. The carbon brushes
are relaceable. The tool yields an interference suppression of
12 dB below EMI class N; thus it is suitable for application
with telecommunication devices. The index angle can be
adjusted without tools in stps of 45° after loosening the
adjustment nut, allowing for adaptation to the handling of the
wires and their outgoing direction. The wrap bits and sleeves
can also be exchanged without tools. While model 29315AA3
has a rigid shaft the wrap pawl is displaced axially against
the spring pressure during the wrap process. Wrap bits and
sleeves are available for all current wires and wrap pawls.
Wires from AWG 30 to AWG 22 can be processed with CSW
bits (for combined cutting and stripping). The wrap bits and
sleeves are not included in standard delivery and have to be
ordered separately.
3. Commissioning
For the installation of the wrap bit and the sleeve, the nut has
to be loosened. First insert the wrap bit into the collet, then
the sleeve. The sleeve has to locked into the retention pin.
Technical data:
Power supply:
Power consumption:
Intermittent operation:
Wrapping range:
Fuse:
EMI suppression: 1
5
Then fasten the nut manually while the tool is operating. If
you want to change the index angle, loosen the adjustment
nut and rotate the whole collet assembly into the desired
position.
Maintenance
Disconnect mains power plug before carrying out any main-
tenance work. The assembly of the tool has to be performed
as shown in the exploded view. When mounting it is impor-
tant to align motor and gearing carefully. The planetary
gearing and the slip friction clutch have to be lubricated after
each dismounting with grease type ESSO BACON 2. For
replacing the carbon brushes lift the spring clips, replace the
used brushes by new ones and put the spring back into
place.
4. Accessories
For wrap bits and sleeves refer to the Wire-Wrap Catalogue.
5. Scope of supply
The tool is delivered without accessories.
Operating instructions
Safety Information
Exploded Illustration page 13
Subject to technical alterations and amendments!
230 V, 50-60 Hz
30 W
2 sec. ON / 18 sec. OFF
AWG 30 to AWG 18
315 mA slow
2 dB below class N