Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
1
4
Mark Location, Find a position next to Hub 2000, one person fixes the
1
Microinverter on the wall with his hands, and the other person marks
the positions of the two screw holes of the Microinverter with a marker.
Drilling,drill two diameter 8mm mounting holes at the two marked
2
positions.
Installing yellow plastic expansion tube of screws, Respectively Install
3
the yellow plastic expansion screw tube into the two holes which step
2 drilling.
Installing Microinverter, One person fixes the Microinverter with both
4
hands on the wall and align the hole drilling in step 2, then put the flat
Washers on the screws,at last screw
into the yellow plastic expansion tube .
Tighten the screws，screws the rest of
5
wall completely.Then you also have completed the installation of
Microinverter.
5.3.6 Stack AB1000 or AB2000
Before stacking AB1000 or AB2000, please pay attention to the note on
the top of AB1000 or AB2000.
1
Remove the plastic protective covers on the connection port ,then
1
please align the left side first.
Slowly insert the battery connection port.
2
Tips:The Hub 2000 can only be connected to a SuperBase V without a
Satellite Battery, or it can only be connected to one Satellite Battery
without a SuperBase V. Multiple batteries are not supported.
2
1
2
5
&
screws with flat Washer
1
2
&
1
2
2
2
2
1
1
3
screw into the
EN
13
Publicidad
