IKRA ICC 2/2035 Instrucciones De Manejo página 43

WARNING
If the machine is dropped, suffers heavy impact or
begins to vibrate abnormally, immediately stop
the machine and inspect for damage or identify
the cause of the vibration. Any damage should be
properly repaired or replaced by an service station.
Residual Risk
• Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual
risk factors. The following hazards may arise in use and
the operator should pay special attention to avoid the
following:
• Injury caused by vibration
Always use the right tool for the job. Use designated
handles. Restrict working time and exposure.
• Damage to hearing due to exposure to noise
Wear hearing protection and limit exposure.
• Injury caused by contact with exposed saw teeth of the
chain
• Injury caused by thrown-out pieces of the workpiece
(wood chips, splinters)
• Injury caused by dust and particles
• Injury to the skin caused by contact with lubricants
• Parts ejected from the saw chain (cutting/injection
hazards)
• Unforeseen, abrupt movement, or kickback of the guide
bar (cutting hazards)"
ASSEMBLY
Assembling saw chain and guide bar
WARNING
If any parts are damaged or missing do not operate
the machine until the parts are replaced. Failure to
heed this warning could result in serious personal
injury.
Make sure to remove the battery. Wear protective gloves.
WARNING
The saw chain is sharp. Always wear protective
gloves when performing maintenance to the chain.
Risk Reduction
• It has been reported that vibrations from handheld
tools may contribute to a condition called Raynaud's
Syndrome in certain individuals. Symptoms may inclu-
de tingling, numbness, and blanching of the fingers,
usually apparent upon exposure to cold. Hereditary
factors, exposure to cold and dampness, diet, smoking
and work practices are all thought to contribute to the
development of these symptoms. There are measures
that can be taken by the operator to possibly reduce
the effects of vibration:
• Keep your body warm in cold weather. When operating
the unit wear gloves to keep the hands and wrists
warm.
• After each period of operation, exercise to increase
blood circulation.
• Take frequent work breaks. Limit the amount of expo-
sure per day.
• Protective gloves available from professional chain saw
retailers are designed specifically for chain saw use
which give protection, good grip and also reduce the
effect of handle vibration. These gloves should comply
with EN 381-7 and must be CE marked.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor.
WARNING
Injuries may be caused, or aggravated, by
prolonged use of a tool. When using any tool for
prolonged periods, ensure you take regular breaks.
Adjusting the chain tension (p. 5)
Remove the battery pack before you do any work on the
chain saw.
To increase the chain tension, turn the chain tensioning
screw clockwise and check the chain tension frequently.
To reduce the chain tension, turn the chain tensioning
screw counterclockwise and check the chain tension
frequently.
and measure the distance between the bar and the teeth
of the chain cutters. Tighten the bar mounting nuts
(Fig. 4) by turning it clockwise.
Note Do not over-tension the chain - excess tension will
cause excessive wear and will reduce the life of the chain
and could damage the bar. New chains could stretch
and loosen during initial use. Remove battery pack and
check chain tension frequently during the first two hours
of use. The temperature of the chain increases during
normal operation causing the chain to stretch. Check the
chain tension frequently and adjust as required. A chain
tensioned while warm may be too tight upon cooling.
Make sure that the chain tension is correctly adjusted as
specified in these instructions.
EN ENGLISH
41