Voltor V 20-E Manual De Instrucciones página 36

6.3. POINTS TO BE CHECKED PRIOR TO USING THE
MACHINE
The electric current and electric tension must
comply with those on the characteristics label of the
machine. Before starting to work with the machine,
always check the machine works correctly and
securely. Check the machine and ensure all nuts are
tightly secured, there are no lose pieces. Replace or
repair any broken pieces that you may have seen to be
in a bad state. Ensue there are no oil leakages. Do not
use the machine if damaged or incorrectly regulated.
6.3.1 VERIFICATION OF THE CHAIN BRAKE
When the machine kicks back, the tip of the bar
elevates itself and the machine changes angle sharply
not allowing the end user to change the arms position
and the arm hits against the security protector and
this activates the chain brake. The chain brake stops
the engine in 0.15 seconds.
The chain brahe can be activated at any moment
by pushing the security protector forward. To
remove the chain brake, pull the security protector
back until you hear a click.
36/148
Working position.
Blocking position.
click. Hold the machine horizontally at a distance from
the wood of some 40cm, remove the hand holding the
front handle and allow the machine to carefully fall
until the tip of the bar touches the piece of wood. If
the brake works correctly the chain should not move
when it contacts the piece of wood. If this is not the
case and the chain moves, you must take the machine
to your nearest after sales agent for the machine to
be repaired.
6.3.2. CHAIN OIL
Only use oil specfically recommended for chainsaws.
Do not use already used oils or oils with impurities as
this could damage the oil pump of the machine.
The chain oil must be introduced in the chain oil
deposit. To avoid dirt and impurities entering the
interior of the deposit, clean the oil cap of the deposit
before opening it. Close the cap of the oil level and
clean if any oil has fallen outside the deposit.
Check the level of the oil by looking at the oil level
gauge.
Check the chain brake
every time you use the
machine prior to start up.
To do this and with the
machine not on the mains,
activate the chain brake
by pushing the security
protector until you hear a
MIN: When only 5mm
approximately are visible in
the lower oil level.
MAX: Oil level full at the top
level of the gauge.