Descargar Imprimir esta página

Hendi SPEEDOVEN X90 Manual Del Usuario página 20

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 117
Troubleshooting
GB
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems
Possible cause
The appli-
Main power is
ance has not
disconnected
electricity
The appliance has
not connected to
power supply.
Hi-limiter is tripped.
The appli-
The door is not
ance does
closed properly.
not heat up
The appliance is not
switched on.
Close door
Food blocks the door
but it still
from closing
pops up
The door is not
"Door Open"
closed properly
notice
Door interlock
switch is malfunc-
tion
The foods
The appliance is
are not
dirty (a lot grease,
cooked well
carbon and food
or up to
debris will wear
standard
down microwave)
Choose wrong menu
Food was not at the
right initial condition.
Too much foods.
Shown
Temperature probe
temperature
is malfunction
probe is
broken
Cooking
Check if these
temperature
following parts are
is low
blocked: Jet plate,
return air inlet, air
filter and catalytic
converter.
The appliance does
not reach the pre-
heat temperature.
20
Possible solution
Turn on the main
power and restart the
appliance
Check if it is connected
to power supply
1. Wait for completely
cooling down.
2. Reset the hi-lim-
iter, see "RESET
the safety cut-out
(Hi-limiter or ther-
mal cut-out)"
3. Connect the power
supply and reboot
the appliance again.
Clear barrier, close the
door properly
Switch on the appliance
and heat up
Clean barrier, close the
door properly.
Repeat open and close
to check if it is properly
closed
Contact the supplier
Cleaning the appliance
and parts according to
"Cleaning & mainte-
nance"
Check if the correct
menu and program
have been chosen.
Make sure the food is
not frozen or chilled.
Reduce the capacity of
the foods.
Contact the supplier
1. Check if they are not
blocked.
2. Cleaning the appli-
ance and parts ac-
cording to "Cleaning
& maintenance".
Wait the appliance
to reach the preheat
temperature and leave
it idle for 5 minutes
Magnetron is
Heating element is
too hot
malfunction
Motor blower
Cool air does not
is too hot
enter into the oven.
Warranty
Any defect affecting the functionality of the appliance which
becomes apparent within one year after purchase will be re-
paired by free repair or replacement provided the appliance has
been used and maintained in accordance with the instructions
and has not been abused or misused in any way. Your statutory
rights are not affected. If the appliance is claimed under war-
ranty, state where and when it was purchased and include proof
of purchase (e.g. receipt).
In line with our policy of continuous product development we
reserve the right to change the product, packaging and docu-
mentation specifications without notice.
Discarding & Environment
When decommissioning the appliance, the prod-
uct must not be disposed of with other household
waste. Instead, it is your responsibility to dispose
to your waste equipment by handing it over to a
designated collection point. Failure to follow this
rule may be penalized in accordance with applicable regula-
tions on waste disposal. The separate collection and recycling
of your waste equipment at the time of disposal will help con-
serve natural resources and ensure that it is recycled in a man-
ner that protects human health and the environment.
For more information about where you can drop off your waste
for recycling, please contact your local waste collection compa-
ny. The manufacturers and importers do not take responsibility
for recycling, treatment and ecological disposal, either directly
or through a public system.
DEUTSCH
Sehr geehrter Kunde,
Vielen Dank, dass Sie dieses HENDI Gerät gekauft haben. Le-
sen Sie dieses Benutzerhandbuch sorgfältig durch und achten
Sie dabei besonders auf die unten aufgeführten Sicherheits-
vorschriften, bevor Sie dieses Gerät zum ersten Mal installie-
ren und verwenden.
Sicherheitshinweise
• Verwenden Sie das Gerät nur für den vorgesehenen Zweck,
wie in diesem Handbuch beschrieben.
• Der Hersteller haftet nicht für Schäden, die durch unsach-
gemäßen Betrieb und unsachgemäßen Gebrauch verursacht
werden.
GEFAHR! STROMSCHLAGGEFAHR! Versuchen Sie
nicht, das Gerät selbst zu reparieren. Tauchen Sie die
elektrischen Teile des Geräts nicht in Wasser oder andere
Flüssigkeiten. Halten Sie das Gerät niemals unter fließendem
Wasser.
• VERWENDEN SIE NIEMALS EIN BESCHÄDIGTES GERÄT!
Überprüfen Sie die elektrischen Anschlüsse und das Kabel
Contact the supplier
Remove substance and
dust that are block-
ing air filter at inlet
according to "Cleaning
& maintenance"

Publicidad

loading

Este manual también es adecuado para:

281260