Operating Instructions - Faro EDI Manual De Uso

OPERATiNG iNSTRuCTiONS

The Edi lamp is designed to illuminate the oral cavity during intervention
procedures in the dentist's surgery. The optical parameters are obtained by positioning
the lamp at a distance of 700 mm from the subject. At different distances the light
spot may lose its optimum parameters in terms of size, homogeneity and illuminance.
It is therefore advisable to work as close as possible to this distance.
Mod. S/TS "edi" Dental Lamp
Use of the lamp is limited to the following operations:
• Turning on
Mechanical. Use Switch "A"
⇒
ON
By Sensor. Place hand within not more than 3 cm distance of Sensor "B"(fig 2)
⇒
on / oFF
Adjusting Light Intensity
•
⇒ Use Wheel "C" to adjust light intensity (fig 3).
Assembling forked lower handle (on request)
To insert forked lower handle proceed as follows:
• Remove front screen (fig.4 pag.20)
• Remove plugs by acting on points "M" (fig.10)
Insert forked lower handle by pressing on points "L" (fig.9).
•
Release it when fitted in the holes.
PLUGS oR FoRkED LowER hAnDLE ShoULD bE ALwAyS
FITTED In ThE hEAD whILE LAMP IS woRkInG
FoR FIxED hAnDLES USE DISPoSAL CovER
(fig.1)
oFF
22