Publicidad
Idiomas disponibles
Idiomas disponibles
J
ASSEMBLY INSTRUCTIONS
7a. Find Adjustable Shelf (7).
7b. Insert shelf supports (14) into the desired holes inside each
side compartment. Make sure you place the six shelves
supports at the same level to level the shelf, then put in the
adjustable shelf (7).
To remove the shelves, push the tabs on the shelf supports
and lift the shelf.
Hardware Used
14
Shelf Support
8a. Find Right Front Panel (3) and the remaining 2 Triangular
Supports (11,12).
8b. Match up "H" label on one Triangular Support B (12) with
"H" label on Right Front Panel (3) and click together. Make
sure the connection is flush across the entire joint and there
are no gaps between the two panels.
8c. Match up "I" label on the other Triangular Support A (11)
with "I" label on Right Front Panel (3) and click together.
Make sure the connection is flush across the entire joint
and there are no gaps between the two panels.
9a. Find Short Wood Brace (6).
9b. Match up "J" label on Short Wood Brace (6) with "J" label on
Right Front Panel (3) and match up "R" label on Short Wood
Brace (6) with "R" label on Triangular Support B (12) and click
together. Make sure the connection is flush across the entire
joint and there are no gaps among the three panels.
7
7
x 6
8
12
3
H
H
9
J
3
R
R
J
6
Click
6
ASSEMBLY INSTRUCTIONS
10a. Find Long Wood Brace (5)
10b. Align and attach Long Wood Brace (5) to the Short Wood
Brace (6) with three 30 mm Screws (19) as shown. Secure
the screws with a Phillips screwdriver.
10c. Insert two Shelf Supports (14) into the desired holes on Right
Front Panel (3). Make sure they properly match the Adjustable
Shelf (7) installed.
Hardware Used
19
M4 x 30 mm Screw
14
14
Shelf Support
Tab
11a. Match up "K" labels on Long Wood Brace (5) with "K" label on
the Triangular Support C (13) and click together. Make sure
the connection is flush across the entire joint and there are no
gaps among the three panels.
11
11b. Match up "L" label on Long Wood Brace (5) with "L" label on Left
Front Panel (2) simultaneously and click together. Make sure the
connection is flush across the entire joint and there are no gaps
among the three panels.
I
11c. Repeat the same process to attach Right Front Panel (3) and
Triangular Support A (11) to Bottom Panel (1) and Right Back
Panel (9) by matching up "N", "O" and "M" labels simultaneously
and click together.
I
Click
12a. Insert one 30 mm Screw (19) into the mounting hole on
Right Back Panel (9) and securely screw into the end of Long
Wood Brace (5). Tighten the screw with a Phillips screwdriver.
Hardware Used
19
M4 x 30 mm Screw
12
10
12
11
6
5
3
x 3
x 2
14
19
11
K
Click
11
5
L
M
3
O
1
N
M
9
O
Click
12
19
5
x 1
9
7
13
2
K
L
Publicidad
