Publicidad
Idiomas disponibles
Idiomas disponibles
KNOW YOUR SYSTEM CONTROL BOARD
Compare this Control Board illustration with your generator to familiarize yourself with the location of these important
controls and connections:
50/60 Hz Switch
12 Volt DC,
.5 Amp Output
12 Volt DC, .5 Amp Output — Internal power supply.
50/60 Hz Switch — Allows factory to select between
either 50 Hz or 60 Hz. Make sure the switch is in the
60 Hz position at all times for proper generator operation.
Emergency Failure — Use NO2, Common2 and NC2 to
hook up a siren, light, etc. to alert you in case of a failure
during a power outage.
Briggs & Stratton Power Products Home Generator
Emergency Failure
Exercise Failure
Installation Manual
Exercise Failure — Use NO1, Common1 and NC1 to
hook up a siren, light, etc. to alert you in case of a failure
during the exercise cycle.
Remote LED Output — Use this to hook up the extra
remote LED supplied with the generator.The remote LED
will turn on and off in a series of blinks if certain faults are
detected in the generator.
10
Remote LED Output
Publicidad
