AENO DI1 Guia De Inicio Rapido página 12

4. Place the device on a flat, stable surface. Open the cover of the USB (C)
port (9) and connect the device to a power supply with the USB (A) / USB (C)
cable (12).
5. Fully charge the device (at least 4.5 hours). When the battery is fully charged,
the charge level indicator will turn green.
Note. The power adapter is not included in the package. Output parameters of
the adapter must be 5.0 V (DC), 1.0 A.
6. Disconnect the device from the power supply and insert the cover into the
USB (C) port of the device.
Operation
1. Open the tank cap (10) and fill the tank with water.
ATTENTION! Use purified water only without mouthwashes and other liquids
or substances.
2. Close the tank cap.
3. Select the required nozzle (see "Intended Purpose of Nozzles") and insert it
into the opening (7) until it clicks into place.
Note. The nozzles can rotate 360°.
4. Rotate the outlet of the nozzle away from yourself and turn the device on
by pressing the power button once.
Note. The first time you turn on the device, it will operate in "High" mode at a
maximum strength level.
5. Select the required mode and its strength with the mode and strength
selection button (see "Operating Modes of the Device" and "Functions of
the Device Buttons"). The name of the selected mode will be displayed on
the control panel of the device.
Note. There is no strength level indicator on the device. The current strength
level can only be distinguished during operation by the head of the supplied
jet of water.
6. After selecting the required operating mode and strength, turn off the
device by pressing the power button once.
12 aeno.com/documents