Publicidad
Idiomas disponibles
Idiomas disponibles
[] Initial
Setup
Thissection will guideyouthroughtheunit'sinitial settingwhichincludes
selecting a languageforyouron-screen menuandautochannel s can,
whichautomatically scans andmemorizes viewablechannels.
Before youbegin:
Makesureifthe unitisconnectedtoantennaorcables.
1
After making
all the necessary connections,
press
[POWER] to turn on the unit.
POWER
• This operation
may take a few moments.
2
Use [Cursor A/T]
to select the on-screen
language
from the choices on the right side of the TV screen.
(English / Espafiol / Fran_ais)
or
• "Initial Setup" menu on step 3 will be displayed
in the
selected language
after you press [ENTER[.
3
Use [Cursor AIr]
to select"Air"
for TV channels or
"Cable" for CATV channels, then press [ENTER[.
or
• Scanning
and memorizing
of channels
start
automatically.
Use [Cursor <11_] to select the desired mode for
energy saving, then press [ENTER[.
or
• Select"Retail"
if you want backlight
to be brighter.
• Select"Home"
to reduce the power consumption.
When the initial setup is completed,
the lowest
memorized
channel with the confirmation
message
of the energy
saving mode will be displayed
on the
TV screen.
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press [POWER] or [SETUP] during auto channel
scan, this setting will be canceled.
• The initial auto channel scan function can be executed
for either "Air" or "Cable" only once. When you change the
connection (Air/Cable), set auto channel scan again.
(Referto page 18.)
• Ifthereisnosignalinputfrom
theantenna terminaland
no operation for several seconds after you turn on the unit,
"Helpful Hints" appears. Follow the instructions listed on
the TVscreen.
• Whenyouselect"Home'brightnessofbacklightdarkens
compared
to "Retail" This is not a malfunction.
After an initial setup is completed...
.......................
C
• If you want to scan the channels automatically
again,
refer to "Auto Channel Scan" on page 18.
• You can add the desired channels unmemorized
by
"Autoscan". Refer to "Manual
Register" on page 20.
• If you want to change the other language from the
one you chose, refer to "Language
Selection"
on
page 21.
• If you want to change the mode for energy
saving,
refer to "Energy Saving Mode" on page 32.
EN
Publicidad
