Descargar Imprimir esta página

Sylvania LC370SS9 Manual Del Usuario página 8

Ocultar thumbs Ver también para LC370SS9:

Publicidad

Idiomas disponibles

Idiomas disponibles

[] Basic Connection
Thissection describes h owto connect t heunit toan antenna,cablereceiver orsatellitebox.
Note:
• Besureyour antenna or other device is connected properly before plugging in the AC power cord.
[Antenna
Connection]
Connect
the RF coaxial cable on your home outlet to the antenna
input jack of this unit.
eogo)
VHF / UHF_
antenna
_
RF coaxial cable
rear of this unit
cableTV
signal
Once connections
are completed,
turn on the unit and begin initial setup. Channel scanning
is necessary for the unit
to memorize
all available
channels
in your area. (Refer to"lnitial
Setup" on page 13.)
Note:
• If you have any question about the DTV'santenna, visit www.antennaweb.org for further information.
• Foryour safety and to avoid damage to this unit, please unplug the RFcoaxial cable from the antenna input jack before moving the unit.
• If you use an antenna to receive analog TV,it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop versions.
• Toswitch your reception source easily between antenna and cable, install an antenna selector.
• If you connect to the cable system directly, contact the CATVinstaller.
[Connection
to Cable Receiver or Satellite Box]
Use an HDMI or an RCA component
video cable to connect the HDMI or the component
video input jack of the unit to the
HDMI or the component
video output jack of the cable receiver/satellite
box.
If you connect
to the unit's COMPONENT1
or COMPONENT2
video input jack, connect
an RCA audio cable to the audio
L/R jack of COMPONENT1 or COMPONENT2
accordingly.
e.g.)
HDMI cable
RFcoaxial
AUDIO
OUT
COMPONENT VIDEO OUT
L
R
I
_y
Pb/Ob
Pr/Cr
rear of this unit
including PPV
cable receiver/satellite
box
You can also connect
this unit to the cable receiver or satellite box other than the HDMI or the component
video
output
jack because they might
have different
output
jacks.
Required
cables and connecting
methods
of the cable receiver / satellite
box, or the availability
channel
for the clear
QAM may differ depending
on the cable/satellite
provider.
For more information,
please contact
your cable/satellite
provider.
EN

Publicidad

loading