EINHELL CC-IW 450 Manual De Instrucciones Original página 15

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
WARNING!
Read all safety warnings, instructions, illust-
rations and specifi cations provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future
reference.
2. Layout and items supplied
2.1 Layout (Fig. 1)
1. ½"external square drive mount
2. Handle
3. Rocker switch (selector switch for forward/
reverse; ON/OFF switch)
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
Anl_CC_IW_450_SPK9.indb 15 Anl_CC_IW_450_SPK9.indb 15
GB
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Electric impact driver
•
Socket wrench bit (4x)
•
Original operating instructions
•
Safety instructions
3. Proper use
This tool is intended to be used primarily for loo-
sening and tightening screws and nuts (e.g. for
automotive work).
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Rated voltage: ........................ 230-240 V ~ 50 Hz
Power consumption: ................................. 450 W
Idling speed: ........................................2600 min
Blow rate: ............................................5000 min
Torque: ....................................................300 Nm
Tool chuck: ...................................... ½"(12.7mm)
Protection class: ............................................ II/
Weight: .......................................................2.3 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
- 15 -
-1
-1
26.02.2024 10:03:21 26.02.2024 10:03:21