LUND 67702 Manual De Instrucciones página 10

GB
PRODUCT OVERVIEW
The smoothie cup blender is designed to prepare food. Thanks to its high power and capacious cup it is possible to prepare meals
easily and quickly by cutting and mixing food products. The cup can be replaced with a bottle which reduces the number of dishes
to be washed after using the blender. The product is intended for domestic applications only, and not for any commercial use. The
correct, reliable, and safe operation of the device depends on its proper use, so:
Reading and keeping the entire manual before the fi rst use of the product is necessary.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual. Use of the product for purposes other than those for which it was intended shall cause the loss of the
user's rights to the guarantee and under warranty.
ACCESSORIES
The product is delivered complete, but requires carrying out a number of preliminary actions described in further sections of the
manual, before starting operation. The following items come with the product: a cup, a cup lid, a 0.57 l bottle with a lid, a 0.4 l
bottle with a lid and a cutting attachment.
SAFETY INSTRUCTIONS
Caution! Read all of the following instructions. Failure to do so may result in electric shock,
fi re, or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids, gases, or
vapours. Before starting the product for the fi rst time, make sure that the product, its acces-
sories, and the power cord have not been damaged. If any damage is discovered, it is not al-
lowed to start working with the product. Any damaged components, including the power cord,
must be replaced at an authorized facility. It is not allowed to repair the product on your own.
The product is intended for indoor use only. Do not expose the product to any precipitation or
moisture. If water and moisture enters the product, the risk of an electric shock is signifi cantly
increased. Do not immerse the product in water or any other liquid. Connect the product to
the power network providing the voltages and frequencies indicated on the nameplate of the
unit, exclusively. The plug of the power cord must match the power socket. Do not modify
the plug. Do not use any power adapters to adapt the plug to the socket. An unmodifi ed
plug, which matches the socket, reduces the risk of an electric shock. After each applica-
tion, unplug the power cord from the power socket. Always disconnect the blender from the
power supply, if it is left unattended, and before putting it away, disassembling, or cleaning.
Do not overload the power cord. Do not use the power cord to carry the product, connect, or
disconnect the plug from the power socket. Avoid any contact between the power cord and
heat sources, oil, sharp edges, and moving parts. Damage to the power cord increases the
risk of an electric shock. If the power cord is damaged (e.g. it is cut, its insulation is melted),
immediately unplug it from the wall socket, and return it to an authorised service facility. It
is not allowed to use the product with a damaged power cord. It is not allowed to have the
power cord repaired. It must be changed for a new one at an authorized service centre. Dis-
connect the power cord from the power socket, before installing, removing, or adjusting
any of the product accessories. Exercise special care, when handling sharp parts of the
product. Do not touch blades in motion. The blades are very sharp and there is a risk
O R I G I N A L I N S T R U C T I O N S
10