Beta 018330013 Manual De Uso E Instrucciones página 6

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
TECHNICAL DATA
LED TORCH
POWER SUPPLY
LIGHT OUTPUT
AUTONOMY
CONNECTION
CHARGE TIME
TOTAL LENGTH
PROTECTION RATING
OPERATING TEMPERATURE
WEIGHT
CHARGING MODE
Torch charge through USB
- To charge the torch, lift the cover of USB port (2) on the back of the handle.
- Connect the cable first to the torch and the power supply, and then to the mains socket, making sure that the mains voltage is
compatible with that of the charger as stated in the TECHNICAL DATA table.
- While the torch is charging, LED charge indicators (5) of the torch will be flashing.
- When charge is completed, 3 LEDs (5) will turn solid green.
- When the torch is fully charged, disconnect it from the power supply and close the USB port cover.
Torch charge with wireless charging base 1839BRW.
- The torch must be charged only when it is switched off.
- Place the side of the torch to charge on either slot of the wireless charging base, 1839BRW, making magnet (4) fit the slot. If the
battery charge indicator does not light up or if the charging station flashes red, remove the torch and try again.
- While the torch is charging, LED charge indicators (5) of the torch will be flashing.
- When charge is completed, 3 LEDs (5) will turn solid green.
- When charge is completed, the torch can be disconnected from the wireless battery charger.
6
High-power COB LED
Battery 3.7V 2600 mAh, 9.62 Wh Li-ion
ca. 1000 lm – Full-power mode
ca. 400 lm – Normal mode
ca. 30 lm – ECO mode
ca. 5 lm – Read-out mode
ca. 2 h – Full-power mode
ca. 4 h – Normal mode
ca. 38 h – ECO mode
ca. 200 h – Read-out mode
5V DC 1A-USB-C/Wireless
4 h
160 mm
IP 68, IK 07
-10°C +40°C
215 g
EN
1. ON/OFF BUTTON
2. USB C-type port
3. Mode switch
4. Magnet
5. LED light charge indicator
I