EINHELL TP-RS 18/32 Li BL Manual De Instrucciones Original página 16

•
Remove the dust collection box in reverse
order.
•
Using the dust extraction adapter (2) you can
also connect the equipment directly to a sui-
table vacuum cleaner (Fig. 2b).
Caution!
For health reasons it is imperative that you use
the dust collection box or a dust extraction sys-
tem.
5.2 Emptying the dust collection box
(Fig. 3/Item 4)
•
To empty the dust collection box (4), open it
as shown in Fig. 3 and clean it thoroughly.
•
The filter is held by a bayonet fastener and
can also be removed for cleaning with com-
pressed air if necessary.
•
Then everything must be reassembled in
reverse order.
•
Finally the dust collection box (4) can be refit-
ted on the dust extraction adapter (2).
5.3 Fastening the abrasive paper with the
Hook-and-loop fastening system (Fig. 4)
•
Only use abrasive paper with the correspon-
ding dimensions and matching perforations.
•
Place the abrasive paper onto the oscillating
plate (5) as shown in Fig. 4. Make sure that
the perforations in the abrasive paper coinci-
de with the oscillating plate.
•
To remove the abrasive paper, simply pull it
off.
6. Operation
6.1 Charging the Li battery pack (Fig. 5-6)
1. Remove the battery pack (6) from the handle,
pressing the pushlock button (b) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
(7) into the socket outlet. The green LED will
then begin to blink.
3. Push the battery pack onto the battery char-
ger.
In section 10 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
Anl_TP-RS_18-32_Li_BL_SPK13.indb 16
GB
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
6.2 Battery capacity indicator (Fig. 7/Item c)
Press the button for the battery capacity indicator
(d). The battery capacity indicator (c) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
- 16 -
11.09.2023 08:51:13