Publicidad
Idiomas disponibles
Idiomas disponibles
Storage
PREPAPJNG
THE
fJN[T
FOP, STORAGE
Water shouldnot remain inthe unitforlongperiods of
time. Sedimentsor minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the pressure
washer for more than 30 days, follow this procedure:
I.
Flush detergent siphoning tube by placing filter into a
pail of dean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2.
Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect
spark phg wire
from spark plug.
3.
Empty pump of liquids by pulling engine recoil handle
about 6 times.This
should remove most liquid in pump.
4.
Use pump saver to prevent corrosion
build up and
freezing of pump.
5.
Store unit in a ciean_ dry area.
Protecting
the Pump
To protect
the pump from damage caused by mineral
deposits
or freezing, use PumpSaver
to treat pump.This
prevents
freeze
damage and lubricates
pistons
and seals.
NOTE:
PumpSaver is available as an optional accessory, it is
not included with the pressure washer. Contact the nearest
authorized
service center
or visit your local Lowe's store to
purchase
PumpSaver.
• Failure to do so will permanently
damage
your pump and
render
your unit inoperable,
• Freeze
damage
is not covered
under
warranty.
CAUTION
Always wear eye protection when using PumpSaver.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected
from supply water. Read and
follow all instructions
and warnings given on the PumpSaver
container.
NOTE:
PumpSaver
will drip from pump after treatment
and will stain wood and concrete.
NOTE:
If PumpSaver
is not available, draw RV antifreeze
(non-alcohol)
into the pump by pouring
the solution
into a
3°foot section
of garden
hose connected
to inlet adapter
and pulling recoil handle twice.
STORING
THE ENGINE
See the engine
owner's
manual
for instructions
on how
to
properly
prepare
the
engine
for storage.
Publicidad
