GE AEZ24 Manual Del Propietario Y Instrucciones De Instalación página 9

JnstaJlationinstructions
[] WINDOW REQUIREMENTS
• These instructions are for a standard double-hung
window. You will need to modify them for other types
of windows.
• All supporting parts must be secured
to firm wood, masonry or metal,
• The electrical outlet must be within reach of the
power cord,
• Follow the dimensions in the table and illustration
for your model,
19 1/4"
_-------29" - 41 "
(With accordion panels)
I
1
171STORMWINDOW REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will keep it
from draining properly.
To
adjust for this,
attach
a piece
of wood
to
the sill,
WOOD PIECES
WIDTH: 2"
LENGTH: Long enough to fit inside the window
frame,
THICKNESS: To determine the thickness, place a
piece of wood on the sill to make it 1/2" higher
than the top of the storm window frame or the vinyl
frame,
Attach securely with nails or screws provided by the
installer,
1/2" higher
than storm
window
frame
Storm window
frame
1/2" higher
than vinyl frame
_ _ (on sorne windows
L-] _ Wood
- r_ Vinyl frame
I !
9
[_ PREPARETHE AiR CONDITIONER
r_ Pull down the front panel and remove the filter.
Remove the front panel by lifting up at an
angle.
r_ Remove the four front screws. Save them
for reinstalling the front housing.
rc] Grasp the lower corners of the grille while
pressing in on the case sides with your
finger tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge
toward you more than 3" or you may
damage the tabs of the grille.
t t
r51
When the front grille is removed the
control panel will still be attached by
a harness. Turn the grille around so
you can see the back side of the grille.
Remove the 2 screws to separate the
control panel housing from the grille.
NOTE: Be sure to save these screws. You will
need them later in the installation.
Remove Screws