Nice WEGO BIO PRO Manual Del Usuario página 97

22.4.2 - CAN NETWORK
When selected to operate on the CAN network, all WeGo Bio Pro equipment must be configured with the same baud
rate, whether 125kpbs or 250kbps. Do not use communication at 20kpbs as it is too low a rate to operate on a net-
work.
Below is the drawing of the end-of-line switch of the CAN network, near the main connector of the WeGo Bio Pro.
It is also important to differentiate the equipment by means of the equipment address, where address 1 will always
be that of the DATABASE and REGISTRATION LOCATION. Other equipment must be configured with non-repeating
addresses.
The topology used in the assembly is the bus topology, connecting the end of the line ONLY on the first and last
device.
97
ENGLISH