Publicidad
Idiomas disponibles
Idiomas disponibles
We recommend that you use our depth gauge
tool to receive the correct depth gauge setting
and bevel for the depth gauge.
1. Use a flat file and a depth gauge tool
to adjust the depth gauge setting. Only
use the recommended depth gauge tool
to receive the correct depth gauge setting
and bevel for the depth gauge.
2. Put the depth gauge tool on the saw chain.
Note:
See the package of the depth
gauge tool for more information about how
to use the tool.
3. Use the flat file to remove the part of
the depth gauge that extends through the
depth gauge tool.
Note:
The depth gauge setting is correct
when you do not feel resistance as you
move the file along the depth gauge tool.
To tension the chain
WARNING:
incorrect tension can derail from the
guide bar and cause serious injury
or death.
A saw chain becomes longer when you use it.
Adjust the saw chain regularly.
2113 - 004 - 03.11.2023
A saw chain with an
1. Loosen the bar nut that hold the clutch
cover/chain brake. Use the combination
wrench.
2. Tighten the bar nuts by hand as tightly as
you can.
3. Lift the front of the guide bar and turn
the chain tensioning screw. Use the
combination wrench.
4. Tighten the saw chain until it is tight
against the guide bar but still can move
easily.
5. Tighten the bar nuts using the wrench and
lift the front of the guide bar at the same
time.
6. Make sure you can pull the saw chain
around freely by hand and that it does not
hang from the guide bar.
25
Publicidad
