GB
Cleaning and care
WARNING!
RISK OF ELECTRIC SHOCK
Switch the appliance off and disconnect it from the mains before cleaning or
user maintenance.
Never hold the appliance under running water or immerse it in water or other liquids.
Clean the main unit by wiping it with a slightly damp cloth.
Do not use harsh or abrasive cleaning agents or cleaning pads.
Cleaning the air inlet grille
Clean the air inlet grilles regularly to avoid blockages caused by dirt and dust.
Both grilles can be removed for cleaning.
The filter behind the right-hand grille can be easily removed by loosening the 2 inner screws.
The filter cannot be cleaned with water, only removed and brushed or tapped.
The grilles can be rinsed under running water if necessary.
Allow all parts to dry completely before reinserting them into the appliance.
Cleaning/emptying the water tank
Disconnect the appliance from the power supply.
Pull the water tank out of the appliance a little.
Release the pump by pressing the two side lugs towards each other and carefully remove the pump from the tank.
You can now carefully remove the tank. Take care not to damage any connections.
Clean the tank thoroughly and allow it to dry completely.
To reinsert, lift the pump and hose with one hand and carefully push the tank a little into the appliance.
Secure the pump in its intended position and snap the bracket back into place.
Push the tank fully into the appliance.
Storage
Switch off the appliance and disconnect the mains plug from the socket.
Empty the water container and allow the paper filter to dry completely.
Store the device upright in a cool, dry place.
Do not cover it with an airtight cover.
Troubleshooting
Only for electrical appliances
WARNING!
Switch off the appliance and disconnect the mains plug before addressing any faults! Failure to do so may result in
injury or electric shock.
18
Instruction manual