Publicidad
Idiomas disponibles
Idiomas disponibles
If the appliance is not to be used for a long period of time:
•
Remove the drain plug to drain the remaining water. Replace the drain plug once the water
has completely drained.
•
Leave the lid open so mould and bacteria do not grow.
•
Make sure the appliance is completely dry.
troubleshooting guide
Problem
The empty water
tank indicator
lights up.
The ice cube
basket full
indicator
lights up.
The ice cube
basket full
indicator lights
up, but the tray is
not full.
The ice cubes
produced are too
large or stuck
together.
Possible cause
There is not enough
water and/or the filter
in the water tank is
blocked.
There is air or dirt in the
water pump.
The ice cube basket is
full.
The ice cube basket
full infrared sensors are
iced up or not working
properly.
The temperature of the
water or the ambient
temperature is too low.
Solution
Check the filter is not blocked. Clean it with
a soft cloth. Then:
1.
Add water to the maximum level.
2.
Wait 3 minutes.
3.
Press the ON/OFF button to restart the
ice-making program.
If the problem persists, drain the water from
the water tank and run the cleaning program
to flush through the pipes (refer to the
"Cleaning and maintenance" section).
Contact the after-sales service of your store.
Remove the ice cubes from the tray.
1.
Remove any ice from the infrared
sensors.
2.
Press the ON/OFF button to restart
the appliance. If the problem persists,
contact the after-sales service of your
store.
Fill the water tank up to the MAX mark with
water that has a temperature of at least 8°C
and up to 25°C.
19
Publicidad
