Aiwa NSX-A111 Manual De Instrucciones página 12

A OPEN/CLOSE
3,7
)
.. . .. ..
4
4 ~:: _:~-
.~-—.
1,8
6,8
u
'... _ /./,
5
3,7
The Al edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length.
If necessary, the order of tracks is rearranged so that no track is
cut short,
(Al: Artificial Intelligence)
1
2
3
4
5
Insert the tape to be recorded on into deck 1, and
wind up to the beginning of the front side.
Press W4 to open the cassette holder and insert the tape
with the exposed side down. Wind up the tape with *.
Press CD and load the disc(s).
Press C!3 EDIT/CHECK once while pressing
SHIFT on the remote control.
"EDIT" is displayed.
EDIT
When '(PRGM" is displayed, press
CD EDIT/CHECK
while
pressing
SHIFT
again.
Press DISC DIRECT PLAY 1-3 to select a disc.
Press numbered buttons O-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and O.
In a few seconds, the tracks to be recorded on each side of
the tape are determined.
- and - are also available to designate the tape length.
Remaining time Programmed
of recording
tracks for side A
6
7
8
Press on deck 1 to start recording on the first
side.
CD play and recording of edited tracks for the first side start
simultaneously. When the end of the tape is reached, deck 1
enters the recording stop mode. After entering the recording
stop mode, go to step 7.
Press CD EDIT/CHECK while pressing SHIFT on
the remote control to display the program for the
second recording.
"B" is displayed.
Turn over the tape in deck 1 and press to start
recording on the second side.
To stop recording
Press /4 on deck 1. Recording and CD play stop
simultaneously.
To
clear the edit program
Press
CLEAR
for CD twice in stop mode so that "EDIV
disappears on the display or = OPEN/CLOSE for CD,
To check the order of the programmed track numbers
Before recording, press CD
EDIT/CHECK
while pressing SHIFT
on the remote control to select side A or B, and press - or
* repeatedly.
Tape side Track number
Programmed
track numbers
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment
1
Press CD EDIT/CHECK while pressing SHIFT on the remote
control to select side A or B.
2 Press DISC DIRECT PLAY 1-3 to select a disc.
3 Press numbered buttons on the remote control to select tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks,
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
The Al edit recording function cannot be used with discs
containing 31 tracks or more. "TR OVER" is displayed if this is
attempted,
I
L Minus mark
Tape l~ngth
Tape side
A: First recording side
B: Second recording side
12
ENGLISH