Publicidad
EN
LCD
Description
Display
The alert icon blinks
The icons of each
occupied battery
compartment and alert
icon blink every 1 second
at the same time on the
LCD screen.
The icon of each
occupied battery
compartment and alert
icon blink every half a
second.
CCS icon illuminates on
the LCD screen
CCS icon blinks on the
LCD screen.
n/a
n/a
OFF
Charging Port Fault
32
ELECTRIC LAWN TRACTOR — TR4200E
Tractor
Audio
Status
Cause
Indicator
Indicator
The blade motor is overloaded.
Flashes
The side discharge chute is
One beep
red
clogged with grass and debris.
There is an interference
between the blade and the
tractor deck.
Keeps
beeping
The battery packs are low on
Flashes
until the
charge and the tractor is in
red
PTO switch
Limp Home mode.
is pushed
downward.
The blade motor was
Flashes
Keeps
interrupted in operation and
red
beeping
the PTO switch is not set to off
position.
The tractor continues forward
Solid
at a set speed without needing
No
green
to step on the accelerator
pedal.
The CCS (cruise control
system) function has failed.
OFF
No
Parking-brake pedal is
depressed to stop the tractor.
The tractor is parked on a
slope and the operator leaves
Keeps
OFF
the tractor without setting the
beeping
parking-brake pedal at the
parking-brake position.
Solid RED n/a
There is no power supply.
Electronic faults, such as the
Solid RED n/a
charging port is in open circuit,
the fuse is blown, etc.
Solution
Raise the deck cutting height or slow the
driving speed to reduce the load of the
tractor.
Clean the side discharge chute after each
use.
Call EGO Customer Service Center
Stop working and return to the battery
charging area.
NOTE: When the tractor is in Limp-Home
mode, the blades are automatically switched
into low rotation speed and meanwhile
the audio indicator will keep beeping.
The operator should push the PTO switch
downward to turn off the blade motors. The
audio indicator will stop beeping after the
blades stop.
The tractor will stop working immediately.
The operator should transport the tractor to
the battery charging area for charging.
This is normal operation. If needed, turn
the CCS function off following the section
"To stop (exit) Cruise Control (CCS)" in the
manual.
The CCS function could not be set when
the tractor is driving at very low speed or is
driving in reverse.
After the parking-brake pedal is released,
press the CCS button and the CCS icon
will illuminate on the LCD, or exit the CCS
function following the instructions in the
section "To stop (exit) Cruise Control
(CCS)".
Set the parking-brake pedal at the parking-
brake position. The parking-brake icon will
illuminate and the sound indicator will stop
beeping.
Check the wall outlet whether there is
220 V-240 V supplied or the socket is good.
Contact EGO customer service center for
repair.
Publicidad
