Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
Rear Panel
Power
The device is compatible with DC 55V, 2A. Plug the provided power
adapter into the designated DC interface on the switch.
Chassis Ground Column
Located on the side of the power supply connector, a grounding terminal connector is used to
provide proper grounding for your Intellinet Network Solutions switch. If you use the chassis
grounding screw, it should be wired to an object that provides earth ground. In rackmount
installations, grounding is typically provided by the metal frame of the mounting rack.
Placement
Prior to use, it is recommended that the switch be placed / positioned:
• on a level surface that can support the weight of the switch
• with a minimum of 25 mm (approx. 1") of clearance
on the top and sides for adequate ventilation
• away from sources of electrical noise: radios,
transmitters, broadband amplifiers, etc.
• where it cannot be affected by excessive moisture
Desktop Installation
Attach the rubber feets to the corners on the bottom
side of the Switch to prevent external vibrations.
Wall-mount Installation
Install two screws into the wall at the distance of
the spaces on the back of the switch.
3
English
Publicidad
