Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING
NOTICE:If this Security.I._garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of
the garage door opener, which provides security against code-theft devices, will be circumvented. Theowner of the copyright in the
garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security+ ® 315 IVIHzremote controls.
USINGTHE "LEARN" BUTTON
ToAdd or Reprograma Hand-he/d Remote Contro/
USING THEMOTION DETECTING CONTROL C ONSOLE
1. Press and releasethe "learn" button on the
motor unit. The learn indicator light will
glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that you
wish to operateyour garage door.
1. Press and hold the button on the hand-held
remote* that you wish to operate your
garage door.
2. While holding the remote button, press and
hold the LIGHT button on the Motion
Detecting Control Console.
F..............................................
3. Releasethe button when the motor unit
lights blink. It has learned the code. If light
bulbs are not installed, two clicks will be
heard.
\1,,
3. Continue holding both buttons while you
press the push bar on the Motion Detecting
Control Console (all three buttons are held).
4. Releasebuttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
\1
/
To Erase A// Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
ress n ho the
e rn uttonon otor
unit until the learn indicator light goes out
T JI
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
*3-Function Remotes (315 MHz)
If provided with your garage door opener, the large button is
factory programmed to operate it. Additional buttons on any
Security.I._*3-Function remote or compact remote can be
programmed to operate
other Security.t._ garage
door openers.
35
Publicidad
