JENN-AIR W10549543A Manual De Uso Y Cuidado página 8

5=
6.
Using the screws removed in Step 1, reinstall the L-beams, to
their new location on the door.
Using the screw removed in Step 2 and the adhesive tape
included in the door installation kit, reinstall the light switch
plate onto the bottom of the door.
7. Reinstall the overlay panel, if removed earlier. See "Install
Custom Overlay Frame."
Replace the Door
1. Make sure the hinge covers are still attached to the L-beams.
2. Remove the screws from the both the top and bottom of the
opposite side of the cabinet.
3. Align the holes in the hinges with the holes in the cabinet.
4=
5.
A. Hinge screws removed in Step 2
B. Holes in cabinet
Using the screws removed in Step 2, loosely fasten the door
to the left-hand side of the cabinet.
For the bottom hinge only, slide the plastic spacer, with the
slots facing downward, between the bottom hinge and the
cabinet.
NOTE: The slots in the spacer go around the screws.
A
IM PORTANT:
• Create custom overlay panel according to the specifications in
the "Custom Overlay Panel" section.
• Jenn-Air is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the refrigerator for service.
Install Custom Frame
1=
Open the door completely to 90 °.
2=
J
Using two people, hold the wooden frame so that the holes in
the frame align with the holes at the top and bottom of the
door. Then, fasten the custom frame to the door using six
wood screws at the top and six wood screws at the bottom.
3=
A
A. M4 x 10 wood screws
Check that the custom frame is aligned with the door and
completely tighten the 12 screws.
A. Bottom hinge spacer
6. Fully tighten the screws.
8