Bestron DFA30 Manual De Instrucciones página 14

OPERATION - General information
The below description goes with the image on page 2.
1. Fan housing
2. Fan blades
3. Speed switches
4. Motor
5. Stand, with rubber feet
6. Power cord and plug
OPERATION - Before use for the first time
Remove the fan from the packaging.
OPERATION - Ventilate (see image 2 on page 2)
1. Put the fan on a horizontal and clean floor.
2. Point the front of the fan in the direction which you wish to ventilate. You can also adjust the fan to obtain
a slightly downward, horizontal, or slightly upward ow of air, tilt the fan housing to the required angle.
3. Put the plug into the wall socket.
4. Switch on the fan by using the switches of one of the three speeds:
a. Position 1, the fan operates at low speed.
b. Position 2, the fan operates at normal speed.
c. Position 3, the fan operates at high speed.
5. Stop the fan by turning the rotary switch to position '0'.
WARNING:
It is inadvisable to expose people to a cold ow of air for a long period of time (in particular, small children
and elderly people).
CLEANING AND MAINTENANCE (SEE IMAGE 3 ON PAGE 2)
Over the course of time dust can accumulate between the spokes in the fan housing, and on the fan blades.
Always begin by trying to remove the dust with a brush and/or vacuum cleaner. If this does not remove all
the dust you can always dismantle the fan and clean it:
1. Remove the plug from the wall socket.
2. Release the clips around the rim of the fan housing.
3. Use a small crosshead screwdriver to remove the crosshead screw at the bottom of the fan housing.
4. Remove the front of the fan housing.
5. Clean the fan blades with a damp cloth. Dry thoroughly with a dry cloth.
6. If necessary, clean the motor housing with a dry cloth or brush.
7. Reassemble the front of the fan housing. Make sure that the fork on the fanhousing rim hooks into the
rim on the fixed half of the fan housing. Also make sure that the holes for the crosshead screw are in line
with each other.
8. Fit the crosshead screw, and tighten it with a crosshead screwdriver.
9. Close the clips around the rim of the fan housing, making sure that the front and back halves of the fan
housing are secured to each other along the entire circumference.
WARNING:
• Verify that the appliance is not connected to the power supply before you clean it.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
14 14
EN EN