Cleco NeoTek 943455PT Manual Del Usuario página 7

1 Product description
As an accessory for NeoTek tools, the Tool Light allows better illumination of the screwdriving location.
2 Use
Requirements
NeoTek tool
Software requirements
Note
Note the order of the software updates:
1. Perform controller software update.
2. Perform measurement card firmware update.
3. Perform TIM firmware update.
4. Perform firmware update for accessories.
3 Installation
Note
Before installing, take the tool out of operation or switch off the controller.
30/50/70ESN(...), 30/50/70EAN(...)
• First accessory: see Figure 01, Page 3
• Second accessory (optional): see Figure 02, Page 3
4 Activating accessories
To activate accessories via the controller:
 Navigator > Advanced > Tool Group > Extended Tool Settings > Tool Light.
For additional settings, see the particular software documentation for the controller.
5 LED signals
LED color
Flashing green
Apex Tool Group
Tool Light 943455PT
Order No.
30 Series...
Angle head, inline
Explanation
Bootloader active.
→ Waiting for application.
If the LED does not stop flashing
defective, see 7 Troubleshooting, Page 8.
P2408MA | 2019-06
943462PT
50 Series...
Angle head, inline
Tool light: S169354-101-R1215 or later
Bootloader: S169353-101 or later
Controller: e.g., S168813-1.8.1 or later
Measurement card: S168025-509 or later
TIM (Tool Interface Module): 1.0.0.3.4
after 5-10 seconds, the application is
1
EN
943464PT
70 Series...
Angle head, inline
7