Publicidad
Idiomas disponibles
Idiomas disponibles
Tool does not operate properly:
Tool operates properly, but
fasteners do not drive fully
Tool operates properly, but
fasteners are driven too deep
Frequent empty nailing
Tool jams frequently
20V Cordless 18 Gauge Brad Nailer
Possible Causes
No nails
Battery is low
Tool is hot
Depth of drive isn't deep enough
Nail is too long for wood
hardness
Depth of drive is too deep
Jammed nails or damaged
nails
Incorrect nails
Damaged nails
Dirty magazine
Possible Solution
Replenish nails
Charge the battery pack
Wait until the tool cools down
Adjust depth of drive
Use nail length that is appropriate for
wood
Adjust depth of drive
Pull up on the tool free jam release
and unhook the latch. Check whether
there are jammed nails or damaged
nails inside. If so, remove the jammed
nails or damaged nails in time.
Verify that nails are the correct size
Replace nails
Clean magazine
13
EN
Publicidad
