Publicidad
Idiomas disponibles
Idiomas disponibles
TOCHECK B RAKE
Iftractor requires more than five(5)feet t o
stop athighest speed inhighest gear o na
level, dryconcrete orpaved s urface, then
brake must b eserviced.
You may also check b rake by:
1. Park tractor o na level, dryconcrete or
paved s urface, depress brake pedal
allthewaydown andengage parking
brake.
2. Disengage transmission
byplacing
freewheel control in"transmission
dis-
engaged" position. Putt f reewheel con-
trol o utandinto theslotandrelease so
itisheld inthedisengaged
position.
Therear w heels m ust l ock and skid
when youtrytomanually push thetractor
forward. Iftherear w heels r otate, then the
brake needs t obeserviced. Contact a
Sears o rother q ualified service c enter.
FRONT WHEEL TOE=IN/CAMBER
Your new tractor front wheel toe-in and
camber is set at the factory and is normal.
The front wheel toe-in and camber are
not adjustable.
If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key - Do not
lose).
3. Repair tire and reassemble.
NOTE: On rear wheels only: align
grooves in rear wheel hub and axle. Insert
square key.
4. Replace washers and snap retaining
ring securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to stow leaks, purchase and
use tire sealant from Sears. Tire sealant
also prevents tire dry rot and corrosion.
Washers
Retaining
Ring
X
o
Axle Cover
_Square
Key (Rear
Wheel
Only)
TO START ENGINE WITH A WEAK BAT=
TERY
_,WARNING:
Lead-acid batteries gen-
erate explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries. Always wear eye protection when
around batteries.
If your battery is too weak to start the
engine, it should be recharged. (See "BAT-
TERY" in the MAINTENANCE
section of
this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
Your tractor is equipped
with a 12 volt system. The other vehicle
must also be a 12 volt system. Do not use
your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1. Connect one end of the RED cable
to the POSITIVE (+) terminal of each
battery(A-B), taking care not to short
against tractor chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of
fully charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
26
Publicidad
