SpeedEPart Agri-Fab 45-0518 Manual Del Usuario página 6

10. Turn the tray upside down.
11. Standing behind the tray, place the long end of the
shaft through the end plate on your right as shown in
figure 8. Place the other end of the shaft through the
end plate on your left. Make sure the bent end of the
middle brace rests flat inside the tongue.
12. Assemble a 3/4" flat washer (N) and a wheel bracket
onto each end of the shaft. Turn each wheel bracket
to point in the opposite direction from the lift lever.
Secure each wheel bracket with a 1/4" x 1-3/4" hex
bolt (B) and 1/4" nylock nut (K). Tighten. See figure 8.
NOTE: If there is not enough room for the wheel bracket on
the end of the shaft, leave off the 3/4" flat washer(s).
LIFT LEVER
3/4" FLAT
WASHER (N)
FIGURE 8
ENGLISH
TONGUE
1/4" x 1-3/4"
HEX BOLT (B)
WHEEL
BRACKET
1/4" NYLOCK
NUT (K)
UPSIDE DOWN VIEW
6
13. Assemble a wheel to a wheel bracket as shown in
figure 9. Use a 1/2" x 3-1/2" hex bolt (A), two 1/2
washers (U), one 1/2" hex jam nut (L), and one 1/2"
nylock jam nut (H). Adjust the nuts so that the wheel
is held securely with minimum end play but will spin
freely. Repeat on other side. See figure 9.
1/2" NYLOCK
JAM NUT (H)
1/2" WASHER (U)
FIGURE 9
14. Tip the aerator back and rotate the middle brace
up against the tongue, aligning it on the side of the
tongue that is next to the slot in the tray. Fasten the
middle brace to the bottom of the tongue using two
3/8" x 1" hex bolts (D) and 3/8" nylock nuts (I). Do not
tighten until final step. See figure 10.
3/8" x 1"
HEX BOLT (D)
3/8" NYLOCK
NUT (I)
MIDDLE
BRACE
FIGURE 10
1/2" JAM NUT (L)
1/2" x 3-1/2"
HEX BOLT (A)
1/2"
WASHER (U)
UPSIDE DOWN VIEW