cecotec IRONHERO 1500 VITAL Manual De Instrucciones página 37

1. Make sure the appliance is unplugged and cooled down.
2. Mix 50% of descaling product and 50% low-mineral water.
3. Remove the water tank as indicated before, open the rubber plug, and carefully pour the
solution into the tank. Put the plug back.
4. Allow it to take effect for 40 minutes and then empty the tank.
5. Fill the tank with clean water, rinse, and empty it. Repeat this step until any odour
disappears.
This process only cleans the water tank.
Do not plug the device during this process.
5. TROUBLESHOOTING
The iron does
not produce
steam
The tank leaks
water
The iron
produces a
loud buzzing or
pumping sound
The iron keeps
producing steam
6. TECHNICAL SPECIFICATIONS
Product reference: 08506
Product: IronHero 1500 Vital
220-240 V~, 50-60 Hz, 1500 W
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
Make sure there is enough water in the tank.
Check whether the corresponding indicator light is illuminated green.
Hold the appliance vertically during use.
Make sure you have not exceeded the maximum tank capacity.
Make sure the water tank and plug are correctly assembled.
Keep the appliance vertically according to these instructions.
Check the water level: if the tank is about to be emptied or is empty, fill
it.
If the tank is empty and the water pump has absorbed air, you need to
fill the tank and press the steam button for a while until the air inside
the pump is removed and starts to absorb water, at which point the
sound will disappear and steam will start to come out.
The steam trigger is in the locked position. Unlock the steam push
button.
ENGLISH
IRONHERO 1500 VITAL
37