Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
• For details on the quality warranty, please read the description in the limited warranty section carefully. On the other hand, normal wear
and tear on the product without functional influence is not covered by the warranty. Also be careful if in the instruction manual, in the part
on use, details such as the mixture of gasoline etc. are not contemplated. this may not be covered under warranty.
7. OPERATION
ENGINE START
WARNING
• The cutting head will start to move when the engine starts.
1. Release the throttle lever and make sure it is fully rearward.
2. Turn the ignition switch to the "RUN" position.
(a) throttle lever (b) ignition switch
3. Push the priming pump several times until the excess fuel comes
out in the clear tube.
(1) fuel primer bulb
4. When the engine is cold, move the choke lever to the closed
position.
(a) choke lever (b) open (c) close
5. Place the unit on a flat and firm place. Keep the trimmer head
clear of objects around it.
6. While holding unit firmly, pull starter rope quickly until engine
starts.
7. After the engine has started, let the engine warm up. Pull back
on the throttle lever.
ENGINE SHUTDOWN
1. Release the throttle lever and crank the engine for half a minute.
2. Turn the ignition switch to the "STOP" position.
NOTE
If the engine does not stop after stopping the switch, close the
choke so that the engine stops after a slight interval.
9
EN
Publicidad
