Publicidad
Idiomas disponibles
Idiomas disponibles
PROCEDURES TO PERFORMED AFTER EVERY 100 HOURS OF USE
9. STORAGE
1. Apply oil to the blade to prevent rust.
2. Empty the fuel tank and put the cap back on.
3. Remove the spark plug cap and pour a small amount of oil into the cylinder.
4. Rotate the crankshaft several times using the starter rope to distribute the oil. Replace the spark plug.
5. Wrap the motor in plastic.
6. Store the hedge trimmer indoors in a dry, dust-free location out of the reach of children, preferably where it is not in direct contact with
the ground and away from heat sources
10. DISPOSAL
When you decide to dispose of the machine, fuel or oil for the machine, be sure to follow your local regulations.
11. TROUBLESHOOTING GUIDE
CASO 1: Boot failure
VERIFICATION
Fuel tank
Fuel filter
Carburetor adjusting screw
spark (there is not)
Spark plug
CASO 2: Engine starts but stalls/dry start
VERIFICATION
Fuel tank
Carburetor adjusting screw
Muffler, cylinder (exhaust port)
Air filter
Cylinder fin, fan cover
1. Remove muffler, insert screwdriver into vent and clean out any carbon buildup. Clean any carbon
buildup from the muffler exhaust vent and cylinder exhaust port at the same time.
2. Tighten all screws, bolts and fittings.
3. Check to see if all traces of oil and grease have moved between the clutch lining and the drum and
have been cleaned with unleaded oil-free gasoline.
POSSIBLE CAUSES
Wrong fuel
The fuel filter is clogged
Exceeds the normal limit
Spark plug is flooded/wet
Incorrect spark plug gap
Disconnected
POSSIBLE CAUSES
Incorrect or old fuel
Exceeds the normal limit
There is accumulated carbon
Full of dust
Full of dust
13
ACTION
Drain and fill with correct fuel
Wipe it off
Adjust it to normal size
Clean it, dry it
Correct it (Distance: 0.6-0.7mm)
Tighten it again
ACTION
Drain and fill with proper fuel
Adjust it to normal size
Delete it
Wash it
Wipe it off
EN
Publicidad
